Product ID:ALKYD LUSTERLESS ENAMEL EARTH BROWN 30099
MSDS Date:01/11/1988
FSC:8010
NIIN:00-598-5462
MSDS Number: BHDPY

CON-LUX COATINGS INC

226 TALMADGE RD
EDISON, NJ 08818-0847
US

Emergency Phone: 908-287-4000

Info Phone: 908-287-4000 / FAX 908-287-9288

Cage: 60189

CON-LUX COATINGS INC

847 EDISON, NJ 08818-0847 US

Telephone: 732-287-4000

Cage: 60189

MINERAL SPIRITS

CAS: 64742-47-8

Fraction By Weight: >1%

OSHA PEL 100 PPM

TALC (CONTAINING NO ASBESTOS)

CAS: 14807-96-6

RTECS: WW2710000

Fraction By Weight: >1%

OSHA PEL 2 MG/M3 RDUST

ACGIH TLV: 2 MG/M3 RDUST; 9192

Routes of Entry: Inhalation:YES Skin:YES Ingestion:NO
Effects of Overexposure:IRRITATION OF EYES AND SKIN MAY OCCUR WITH
OVEREXPOSURE CONTINUED BREATHING OF VAPORS MAY IRRITATE
RESPIRATORY TRACT CAUSING HEADACHE, NAUSEA, AND DIZZINESS

First Aid:EYE:FLUSH IMMEDIATELY W/COPIOUS QTY'S OF WATER FOR 15
MINUTES. SKIN:WASH AFFECT-ED AREAS W/SOAP & WATER.REMOVE
CONTAMINATED CLOTHING. INGST:DRINK 1-2 GLASSES OFWATER TO DILUTE.
DONOT INDUCE VOMITING. IF SPONTANEOUS VOMITING OCCURS KEEP HEADAT
OR BELOW KNEE LEVEL TO PREVENT ASPIRATION INTO LUNGS. INHAL: REMOVE
TO FRESH AIR.RESTORE RESPIRATION IF NECESSARY. GET MEDICAL
ATTENTION IMMEDIATELY.

Flash Point Method:TCC
Flash Point:105F/40.56C
Upper Limits:1.0
Extinguishing Media:FOAM, CO2, DR CHEMICAL, WATER MIST
Fire Fighting Procedures:SMOTHER FLAMES W/ONE OF THE ABOVE
EXTINGUISHING MEDIA. WATER MAY BE USED TO COOLDOWN UNOPENED
CONTAINERS IN VICINITY.
Unusual Fire/Explosion Hazard:DO NOT USE IN AREAS WHERE SPARKS OR OPEN
FLAMES ARE PRESENT.

Spill Release Procedures:ELIMINATE ALL IGNITION SOURCE. CONTAIN SPILL
WITH ABSORBENT MATERIAL & PUT INTO VAPOR TIGHT CONTAINRPREVENT
MATERIAL FROM CONTACTING ANY WATER SOURCESOR SEWERS LEADING TO
SURFACE WATERS. WEAR APPROPRI ATE PROTECTION,EQUIPMENT, &
RESPIRATOR.

Handling and Storage Precautions:STORE IN AREAS DESIGNED TO COMPLY WITH
ANSI/NFPA 30 FLAMMABLE AND COMBUSTIBLE LIQUIDS CODE.
Other Precautions:GROUND CONTAINERS WHEN PURING LIQUIDS AND POWDERS TO
AVOID STATIC CHARGE BUILD UP. DO NOT HANDLE UNTIL MANUFACTURERS
SAFETY PRECAUTIONS HAVE BEEN READ & UNDER-STOOD. PROVIDE ADEQUATE
VENTILATION OR R ESPIRATORY PROTECTION TO REMOVE DECOMP.

Respiratory Protection:IN OUTDOOR OR OPEN AREAS, USE APPROVED
RESPIRATOR TO REMOVE SOLID AIRBORNE PART-ICLES OF OVER SPRAY DURING
SPRAY APPLICATION. IN RESTRICTED VENTILATION AREAS USE APPROVED
RESPIRATOR DESIGN TO REMOVE A COMBINATION OF PARTICLES AND VAPOR.
Ventilation:SUFFICIENT VENTILATION SHOULD BE PROVIDED TO KEEP AIR CON-
TAMINANT CONCENTRATION BELOW CURRENT APPLICABLE OSHA UNITS.
Protective Gloves:IMPERVIOUS
Eye Protection:SAFETY GLASSES
Other Protective Equipment:PREVENT PROLONGED SKIN CONTACT WITH
CONTAMINATED CLOTHING
Work Hygienic Practices:WASH HANDS BEFORE EATING, SMOKING, OR USING
WASHROOM FACILITIES.
Supplemental Safety and Health
NK

HCC:F4
Boiling Pt:B.P. Text:148-323F
Vapor Density:> AIR
Evaporation Rate & Reference:SLOWER THAN ETHER
Percent Volatiles by Volume:57.63

Stability Indicator/Materials to Avoid:YES
OXIDIZING AGENTS
Stability Condition to Avoid:EXTREME HEAT, SPARKS, OR OPEN FLAMES
Hazardous Decomposition Products:MAY PRODUCE HAZARDOUS FUMES WHEN
HEATED

Waste Disposal Methods:DISPOSE OF IN ACCORDANCE WITH FEDERAL, STATE,
AND LOCAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.